COLEMAN

1976-345 NO CUT

Step 1) Follow White Compressor wire to the Run Capacitor “C” Terminal. Disconnect the White compressor wire and connect it to the Blue SoftstartRV wire.

Step 2) Connect the Black SoftstartRV wire to the terminal the White wire was on.

Step 3) Follow the Red compressor wire from the compressor to the “HERM” terminal. DO NOT DISCONNECT RED COMPRESSOR WIRE. Connect the Yellow SoftstartRV wire onto the “HERM” Terminal next to the Red compressor wire if there is no wire on it (see Step 4).

Step 4) IF you see a 2nd Red wire next to the Red compressor wire disconnect it, tape the end and drop it.

Step 5) Remove the Compressor cap. Disconnect the Black Compressor wire. Crimp a Female disconnect on the Brown SoftstartRV wire and Bend that connector at least 45 degrees. Then connect the newly bent Brown SoftstartRV wire on the terminal where the Black wire that you just pulled off the Compressor came off.

Step 6) With a male connector on the Red SoftstartRV wire connect it to the Black wire you just removed from the compressor. Tape the connection.

Before turning the power back on, secure wires to prevent the fan from pulling them in. Turn the Power and A/C breaker on, Turn the Fan on High until you hear it running, Turn the A/C to Auto Cool and set the Thermostat to 55 degrees.

Look at the SoftstartRV for a Green light (There may be a full 3 min delay before the Green light comes on).

When you see the Green Light, Turn the power off and replace all covers, then turn the A/C back on and allow it to run for 30 min at about 2 degrees below the outside temperature which should allow it to cycle a few times.

IF no Green Light comes on after 4 minutes shut the A/C down and contact Tech Support, www.softstartrv.com/support and fill out a ticket.